Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 169)

Brocade Network Advisor SAN + IP User Manual 99
53-1003155-01
IP discovery profiles
3
7. Click Close to close the Discover Setup - IP dialog box.
8. Click Yes on the confirmation message.
Configuring a one-time discovery schedule
To configure a one-time discovery schedule, complete the following steps.
1. Select One Time from the Frequency list.
FIGURE 34 Scheduling tab - One Time
2. Select the time of day you want discovery to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click the Date list to select a date from the calendar.
4. Click the right arrow button to add the schedule to the Scheduled Discovery Cycles list.
5. To finish configuring the discovery schedule, return to “Scheduling discovery” on page 98.
Configuring an hourly discovery schedule
To configure an hourly discovery schedule, complete the following steps.
1. Select Hourly from the Frequency list.
FIGURE 35 Scheduling tab - Hourly
2. Select the minute past the hour you want discovery to run from the Minutes past the hour list.
Where the minute value is from 00 through 59.
3. To finish configuring the discovery schedule, return to “Scheduling discovery” on page 98.
Configuring a daily discovery schedule
To configure a daily discovery schedule, complete the following steps.