Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1176)

1104 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Adding target disk LUNs for encryption
25
The Encryption Disk LUN View dialog box displays. (Refer to Figure 488 .)
FIGURE 488 Encryption Disk LUN View dialog box
The dialog box provides a convenient way to view and manage disk LUNs that are provisioned
from different hosts, identify conflicts between configuration policies on storage systems, and
to provide a launching point for the Add New Path wizard for configuring multiple I/O paths to
the LUN.
The dialog box contains the following information:
• Storage Array selector: Determines which LUN paths are displayed in the table. Enables
you to select a storage array from the LUN view prior to launching the Add New Path
wizard. Only ports that belong to at least one target container are listed.
• Host selector: Used to select a host from the LUN view prior to launching the Add New Path
wizard. Only ports that belong to at least one target container are listed.
• Encryption path table: Should be LUN/Path identified by the following:
- LUN Path Serial #
- Target Port
- Initiator Port
- Container Name
- Switch Name
- Fabric
- State
- Thin Provision LUN
- Encryption Mode
- Encrypt Existing Data
- Key ID
• Remove button: Remove s a selected entry from the table.
3. Click Add to launch the Add New Path wizard.
The Select Target Port dialog box displays. (Refer to Figure 489 .)