beautypg.com

Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual

Page 1160

background image

1088

Brocade Network Advisor SAN + IP User Manual

53-1003155-01

Replacing an encryption engine in an encryption group

25

FIGURE 474

Error Instructions dialog box

8. Review the post-configuration instructions, which you can copy to a clipboard or print for later.

9. Click Finish to exit the Configure Switch Encryption wizard.

Replacing an encryption engine in an encryption group

To replace an encryption engine in an encryption group with another encryption engine within the
same DEK Cluster, complete the following steps:

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to

Figure 376

on page 976.)

2. Select an encryption engine from the Encryption Center Devices table, then select Engine >

Replace from the menu task bar.

The Encryption Group Properties dialog box displays with the Engine Operations tab selected.
(Refer to

Figure 475

.)

You can also display the Engine Operations tab by selecting an encryption group from the
Encryption Center Devices table, selecting Group > Properties from the menu task bar, then
selecting the Engine Operations tab.