Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 2275)

Brocade Network Advisor SAN + IP User Manual 2203
53-1003155-01
IP device properties
E
Configuration Displays one of the following VLAN configuration options:
•
Access mode — Supports MAC address and MAC group
classification.
•
Trunk mode
•
Add — Adds VLAN IDs to the port profiles.
•
Remove — Deletes VLAN IDs to the port profiles.
•
All — Indicates that the port profile allows all VLAN IDs.
•
None — Indicates that the port profile does not allow any VLAN
IDs.
•
All Except <VLAN IDs> — Indicates that the port profile allows
any packet except the VLAN IDs specified.
•
<VLAN IDs> — Indicates that the port profile allows any packet
with the VLAN IDs specified.
NOTE: GVLAN supported Trunk Mode supports the Trunk VLAN and the
Native Trunk classifications with the cTag information.
Native VLAN/VLAN Displays one of the following based on the VLAN configuration:
•
Access Mode — Displays the associated MAC address or MAC group
or both to a VLAN ID.
•
Trunk Mode — Displays the cTag for a VLAN ID or Native VLAN ID or
both.
Associated Domain Lists the domain names associated with the port profile.
QoS tab — DCB mode
Mode The mode of Quality of Service (QoS) assigned to the port (DCB).
DCB Map The DCB map name.
Precedence This number determines the map’s priority. Valid values are from 1
through 100.
Fabric Remap Priority The fabric remap priority of the port. Valid values are CoS 0 through CoS
6, and the default is CoS 0.
Lossless Remap Priority The FCoE lossless remap priority of the port. Valid values are CoS 0
through CoS 6, and the default is CoS 0.
QoS tab — Non-DCB mode (Ethernet PFC with Trust)
Mode The mode of Quality of Service (QoS) assigned to the port (non-DCB).
Trust Indicates whether the Ethernet trust of the port is enabled or disabled.
Flow Control The Ethernet priority flow control mode of the port. Possible modes are
as follows:
•
Off (the default)
•
802.3x pause
•
Tx On or Off
•
Rx On or Off
•
Priority Flow Control. For this mode, the Tx and Rx values for each
CoS display in the table.
TABLE 233 VCS fabric properties (Continued)
Field/Component Description