Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 290)

220 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Software Configuration
5
FIGURE 85 Options dialog box (FTP/SCP/SFTP pane)
3. Select the Use built-in FTP/SCP/SFTP Server option to use the default built-in SCP or SFTP
server.
All active fields are mandatory. The default user name is admin. The full path to the built-in SCP
or SFTP directory displays in the Root Directory field.
4. Select the SCP/SFTP Server check box.
5. Change your password by entering a new password in the Password and Confirm Password
fields.
The default password is passw0rd (where 0 is a zero).
6. Select the protocol (SCP or SFTP) from the Preferred Protocol list.
7. Click Test to test the server.
An “SCP/SFTP Server running successfully” or an error message displays.
If you receive an error message, make sure your credentials are correct, the SCP/SFTP server
is stopped, the remote directory path exists, and you have the correct access permission; then
try again.
8. Click Apply or OK to save your work.
Configuring an external FTP, SCP, or SFTP server
NOTE
For FIPS-enabled Fabric OS switches, you must configure the FTP/SCP/SFTP server communication
to an external SCP or SFTP server to download firmware and allow technical support.
NOTE
SCP is supported on Fabric OS devices running 5.3 and later.
NOTE
SFTP is supported on Fabric OS devices running 7.0 and later.
To configure external FTP, SCP, or SFTP server settings, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select FTP/SCP/SFTP in the Category list.
The FTP/SCP/SFTP pane displays ( Figure 86 ).