Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 829
Brocade Network Advisor SAN + IP User Manual
757
53-1003155-01
Ethernet fabric traceroute
18
•
Right-click the VM and select Diagnostics > Traceroute.
•
Right-click the VCS and select Diagnostics > Traceroute.
The Traceroute dialog box displays (see
). The Source field displays the
corresponding VM MAC addresses by default and the Destination field is blank.
If you do not have the privilege to lauch traceroute, the following warning message
displays:
You do not have privilege to perform this operation.
Click OK to close the warning message.
If VCS is not managed or discovered by the Management application, the following error
message displays:
Unable to launch Traceroute dialog because the selected VM is not connected to VCS or
the VCS is not managed by Network Advisor.
Click OK to close the error message.
FIGURE 297
Traceroute dialog box
2. Enter a MAC address, VM name, or IP address in the Source field or click the Source button to
select or search for a source address from the Select Source - Traceroute dialog box (see
Figure 298
).