Encryption center features – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1048
976
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Encryption Center features
25
•
Using the Encryption Targets dialog box . . . . . . . . . . . . . . . . . . . . . . . . . 1133
•
•
Disk device decommissioning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1134
•
Rekeying all disk LUNs manually . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1138
•
•
•
Viewing and editing switch encryption properties. . . . . . . . . . . . . . . . . . 1144
•
Viewing and editing encryption group properties . . . . . . . . . . . . . . . . . . 1149
•
Encryption-related acronyms in log messages . . . . . . . . . . . . . . . . . . . . 1165
Encryption Center features
The Encryption Center dialog box is the single launching point for all encryption-related
configuration in the Management application. (Refer to
Figure 376
.) It also provides a table that
shows the general status of all encryption-related hardware and functions at a glance. To open the
dialog box, select Configure > Encryption.
FIGURE 376
Encryption Center dialog box
Beginning with Fabric OS 6.4, the Encryption Center is dynamically updated to reflect the latest
changes based on any of the following events:
•
Encryption group creation or deletion.
•
A change in encryption group status or encryption engine status
•
Addition or removal of an encryption group member or encryption engine
If you are using the Encryption Center for the first time, please read the following topics before you
begin to perform encryption operations:
•
on page 977 describes the Role-based Access Control privileges
that are specific to encryption.
•
on page 978 and the topics that follow describe the options available for
the use of Smart Cards for user authentication, system access control, and storing backup
copies of data encryption master keys.
•
on page 988 describes the network connections that must be in place
to enable encryption.