Creating a traffic isolation zone, Adding members to a traffic isolation zone – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1272
1200
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Traffic Isolation zones
26
5. (Optional) If you want to show all discovered fabrics in the Potential Members list, right-click in
the Potential Members list and select Display All.
6. Create the Traffic Isolation zones.
For specific instructions, refer to
“Creating a Traffic Isolation zone”
7. Add members to each zone.
For specific instructions, refer to
“Adding members to a Traffic Isolation zone”
NOTE
You cannot add a Traffic Isolation zone to a zone configuration.
8. Click OK or Apply to save your changes.
The Traffic Isolation zones are saved, but are not activated. The Traffic Isolation zones are
activated when you activate a zone configuration in the same zone database.
Creating a Traffic Isolation zone
Traffic Isolation zones are configurable only on a Fabric OS device. The seed switch must be
running Fabric OS 6.1.1 or later.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Select Domain, Port Index from the Type list.
5. Select New TI Zone from the New Zone list.
6. Enter a name for the zone.
For zone name requirements and limitations, refer to
7. Press Enter.
8. Click OK or Apply to save your changes.
The Traffic Isolation zone is saved, but is not activated.
Adding members to a Traffic Isolation zone
NOTE
Traffic Isolation zones are configurable only on a Fabric OS device.
Use this procedure to add a member to a zone when the member is listed in the Potential Members
list of the Zone DB tab. Only ports can be added as members to a Traffic Isolation zone. You must
add two or more N_Ports as well as all E_Ports on the path between the N_Ports.