Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 246)

176 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Flyover settings
5
The default protocol is Fibre Channel (FC). Depending on which protocol you select, some
of the following properties may not be available:
FC (default)
IP
c. Click the right arrow to move the selected properties to the Selected Properties table.
d. Use the Move Up and Move Down buttons to reorder the properties in the Selected
Properties table, if necessary.
The properties displayed in the Selected Properties table appear in the flyover display.
6. Remove product properties you do not want to display on flyover by selecting the property in the
Selected Properties table and clicking the left arrow.
7. Add connection properties you want to display on flyover by selecting the Connection tab
( Figure 68 ) and completing the following steps.
•
Name
•
Device Type
•
WWN
•
IP Address
•
Domain ID
•
Class
•
Tag#
•
Serial #
•
Vendor
•
Model #
•
Port Count
•
Seed Switch
•
Firmware
•
Location
•
Contact
•
Description
•
Management Link
•
Operational Status
•
Enclosure
•
Reason
•
FID
•
Base Fabric for Transport
•
Base Switch
•
Zone Alias
•
Display Name
•
IP Address
•
Status