Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 849)

Brocade Network Advisor SAN + IP User Manual 777
53-1003155-01
Bulk port configuration
19
The boot image is removed from the boot image repository.
Backing up boot image files
You can back up the boot image files from the repository using the Options dialog box. Refer to
“Backup support” on page 791 for instructions.
Bulk port configuration
Use the Adapter Host Port Configuration dialog box to create and assign port-level configurations to
either a single or multiple adapter ports at a time. You can save up to 50 port-level configurations.
The Management application supports the following default port configurations, which you can
select and assign to one port or multiple ports. You cannot edit the default configurations, but you
can delete them.
• Default Port — The port property. The default value is Enabled.
• Default FDFS — The Frame Data Field Size property. The default value is 2048.
• Default QoS — The Quality of Service property. The default value is Enabled.
• Default TRL — The Target Rate Limiting property. The default value is Enabled.
NOTE
You cannot configure Bulk port configuration through Management Application for Emulex Adapters.
Configuring host adapter ports
To create, edit, duplicate, or delete port configurations, complete the following steps.
Select Host > Adapter Ports from the Configure menu.
The Configure Host Adapter Ports dialog box, shown in Figure 306 , displays.