Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1268)

1196 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
LSAN zones
26
4. In the Potential Members list, select one or more members to add to the zone. (Press SHIFT or
CTRL and click each member to select more than one member.)
If you want to show all discovered fabrics in the Potential Members list, right-click anywhere in
the table and select Display All.
5. In the Zones list, select one or more LSAN zones to which you want to add members. (Press
SHIFT or CTRL and click each zone name to select more than one zone.)
6. Click the right arrow between the Potential Members list and the Zones list to add the selected
members to the zone.
7. Click Activate.
8. Review the information in the Activate LSAN Zones dialog box.
LSAN zones that contain online members are automatically included in the Destination Fabrics
list. For LSAN zones that contain offline members, you can click the right arrow button to
assign these zones to fabrics in the Destination Fabrics list.
9. Click OK to activate the LSAN zones.
A message displays informing you about the effects of LSAN zone activation and asking
whether you want to proceed. Click Yes to confirm the activation, or click No to cancel the
activation.
10. Click OK to continue.
All LSAN zones are activated on the selected fabrics and saved to their respective zone
databases.
11. Click OK to close the Zoning dialog box.
Creating a new member in an LSAN zone
Use this procedure to add a member to an LSAN zone when the member is not listed in the
Potential Members list of the Zone DB tab.
For instructions to add a member to a zone when the member is listed in the Potential Members
list, refer to the procedure
“Adding members to the LSAN zone” on page 1195.
1. Select a backbone fabric from the Connectivity Map or Product List.
2. Select Configure > Zoning > LSAN Zoning (Device Sharing).
The Zoning dialog box displays, with the LSAN scope.
3. Select one or more zones to which you want to add members in the Zones list. (Press SHIFT or
CTRL and click each zone name to select more than one zone.)
4. Click New Member.
The Add Zone Member dialog box displays.
5. Select an option from the Member Type list.
The fields in the dialog box vary based on the Member Type option you select.
6. Fill in the remaining fields in the dialog box.
Click the Help button for additional information on each field.