Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1133)

Brocade Network Advisor SAN + IP User Manual 1061
53-1003155-01
Creating a new encryption group
25
After configuration of the encryption group is completed, BNAthe Management application
sends API commands to verify the switch configuration. See
“Understanding configuration
status results” on page 1082 for more information.
8. Verify the information is correct, then click Next.
The Next Steps dialog box displays. (Refer to Figure 440 .) Instructions for installing public key
certificates for the encryption switch are displayed. These instructions are specific to the key
vault type.
FIGURE 440 Next Steps dialog box
9. Review the post-configuration instructions, which you can copy to a clipboard or print for later,
then click Finish to exit the Configure Switch Encryption wizard.
10. Refer to “Understanding configuration status results” on page 1082.