Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1789)

Brocade Network Advisor SAN + IP User Manual 1717
53-1003155-01
IP Traffic analyzer monitoring and sFlow reports
43
• Mbytes - Size of the traffic in megabytes for the time duration shown on the report.
A subtotal is displayed for each of the top users. This subtotal is displayed by source and
destination IP addresses. If the report is for a device group, the name and IP address of the device
that the traffic accessed appear in parentheses. If the report is for an individual device, only the
source and destination IP addresses appear.
At the end of the report, a subtotal for the remaining network users and a total for the entire
network are displayed.
Viewing IPv4 – Others
The Top IPV4–Others report shows the top users of IPv4 traffic excluding TCP, UDP, or ICMP
services. Complete the following steps to display the report.
1. Select Monitor > Traffic Analysis > Monitor sFlow.
2. On the Monitor sFlow dialog box, choose one of the following options:
• To view a report for a device group, click the report icon for the device group you want.
• To view a report for a device, click the name of the device group to which the device
belongs, and on the Device list page, click the report icon for the device.
3. In the Category list, select L3/L4 Reports.
4. In the Reports list, select IPV4.
5. In the next list, select Others.
A report, similar to other IPv4 reports is displayed; however, instead of the TCP, UDP, and ICMP
columns, a column showing the Layer 4 protocol on the traffic appears on the report.
Viewing IPv6 Top Talkers
The IPv6 Top Talkers reports display the top users of Layer 3 and Layer 4 IPv6 traffic. Reports for
top users of the following services are available:
• All Layer 3 and Layer 4 IPv6 services – Display this report by selecting L3/L4 Reports > IPV6 >
All.
• IPv6 TCP users – Display this report by selecting L3 or L4 Reports > IPV6 > TCP.
• IPv6 UDP users – Display this report by selecting L3 or L4 Reports > IPV6 > UDP.
• IPv6 ICMP users – Display this report by selecting L3 or L4 Reports > IPV6 > ICMP.
• IPv6 users of other Layer 3 and Layer 4 services – Display this report by selecting L3 or L4
Reports > IPV6 > Others.
The IPv6 reports are similar to their IPv4 counterparts, except for the following:
• IPv4 reports show IP addresses in IPV4 format; but, IPv6 reports have IP addresses in IPv6
format.
• IPV4 reports show the TOS/DSCP values; but, IPv6 reports show Traffic Class values.