Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1284)

1212 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Zoning administration
26
A warning message displays informing you that the selected zone members will be replaced
from all zones and aliases in the selected zone DB.
6. Click OK on the message.
7. Click OK or Apply on the Zoning dialog box to save your changes.
Any zones or zone configurations you have changed are saved in the zone database.
Replacing zone members
You can replace one instance of a zone member in one zone, or all instances of the zone member
in all the zones to which it belongs.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Right-click the zone member you want to replace in the Zones list and select one of the
following options from the shortcut menu that displays:
• Replace - To replace the zone member in a selected zone.
• Replace All - To replace all instances of the selected zone member.
The Replace Zone Member dialog box displays.
5. Select the option from the Member Type list that you want to use to identify the replacement
zone member.
For Network OS fabrics, only WWN and Alias are supported.
6. Enter the WWN, name, domain and port index numbers, or alias — whichever is appropriate for
the method you chose in step 5 .
When you choose the WWN method, you may define a name for the replacement zone
member.
7. Click OK.
The new zone member replaces the old zone member in the Zones list and the Replace Zone
Member dialog box closes.
8. Click OK or Apply to save your changes.
Any zones or zone configurations you have changed are saved in the zone database.
Replacing an offline device by WWN
The Management application enables you to replace an offline device by WWN from all zones and
zone aliases in the selected zone DB.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.