Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1969)

Brocade Network Advisor SAN + IP User Manual 1897
53-1003155-01
Configuration rules
47
FIGURE 843 Add Block dialog box
6. Enter a user-defined name for the block in the Name field.
The name must be unique. The name cannot be over 128 characters. The only special
character allowed is an underscore (_).
7. Enter a description of the block in the Description field.
The description cannot be over 1024 ASCII characters.
8. Select the Use regular expression check box to use a regular expression in the Block Start
field.
This enables you to match one or more blocks in the device configuration.
9. Enter the start of a block that you want to match to a block start label in the device
configuration in the Block Start field.
The block start cannot be over 256 characters.
10. Enter the block end that you want to use to match (up to and including this string) in the device
configuration in the Block End field.
The block end cannot be over 256 characters. By default, this field contains an exclamation
point (!). Do not use a regular expression as a block end.
11. Click OK on the Add Block dialog box.
12. Click OK on the Add Configuration Rule dialog box.
13. Click OK on the Add Monitor dialog box.
The updated configuration policy manager displays in the Monitors table of the Configuration
Policy Manager dialog box.
14. Click Close on the Configuration Policy Manager dialog box.
Duplicating a configuration block
Enables you to create a new configuration block based on a predefined or user-defined
configuration block .
1. Select Monitor > Configuration Policy Manager.
The Configuration Policy Manager dialog box displays.
2. Click Edit.