Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 949)

Brocade Network Advisor SAN + IP User Manual 877
53-1003155-01
Layer 2 access control list management
22
FIGURE 337 Add - Layer 2 ACL Configuration dialog box
3. Enter a number for the ACL in the Number field.
For IronWare 5.4 and later, ACL numbers range from 400 through 1399.
For IronWare 5.3, ACL numbers range from 400 through 599.
For IronWare less than 5.3, ACL numbers range from 400 through 499.
4. Select Permit or Deny from the Action list.
5. In the Source Address list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Source Address and Source Mask fields.
a. Enter the source MAC address on which the configuration filters traffic in the Source
Address field.
b. Enter the mask associated with the source MAC address in the Source Mask field.
6. In the Destination Address list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Destination Address and Destination Mask fields.
a. Enter the destination MAC address on which the configuration filters traffic in the
Destination Address field.
b. Enter the mask associated with the destination MAC address in the Destination Mask
field.
7. Enter a specific VLAN ID or select Any from the VLAN list.
8. In the Ethernet Type list, select one of the following options to specify the Ethernet type being
transferred in the Ethernet frame:
• ARP — Address Resolution Protocol
• IPV4-L5 — Internet Protocol, version 4-L5
• IPV6 — Internet Protocol, version 6