Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1169)

Brocade Network Advisor SAN + IP User Manual 1097
53-1003155-01
Configuring encryption storage targets
25
FIGURE 481 Select Hosts dialog box
The dialog box contains the following information:
• Hosts in Fabric table: Lists the available hosts in the fabric.
• Selected Hosts table: Lists the hosts that have been selected to access the target.
• Port WWN: The world wide name of the host ports that are in the same fabric as the
encryption engine.
• Node WWN: The world wide name of the host nodes that are in the same fabric as the
encryption engine.
• Port Name: The user-assigned port name, if one exists; otherwise, the symbolic port name
from the device.
• Port ID: The 24-bit Port ID of the host port.
• VI Port WWN: The world wide name of the virtual initiator port.
• VI Node WWN: The world wide name of the virtual initiator node.
• Host Name: The name of the hosts that are in the same fabric as the encryption engine.
• Port WWN text box: Type a world wide name for a host port.
NOTE
You must enter the host node world wide name before clicking Add, to add the WWN to the
Selected Hosts table.
• Node WWN text box: Type a world wide name for a host node.
NOTE
You must also enter the host port world wide name before clicking Add to add the node
WWN to the Selected Hosts table.
• Device Type: The device type indicated by the fabric’s name service. The value is either
Initiator or Initiator + Target.