Viewing the progress of manual rekey operations – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1212
1140
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Rekeying all disk LUNs manually
25
FIGURE 516
Encryption Target Disk LUNs dialog box
4. Click Add.
The Add Disk LUNs dialog box displays. This dialog box includes a table of all LUNs in the
storage device that are visible to the hosts.
5. Click Re-keying Details.
The LUN Re-keying Details dialog box displays. The dialog box contains the following
information:
•
Key ID: The LUN key identifier.
•
Key ID State: The state of the LUN rekeying operation.
•
Encryption Algorithm: The algorithm of the LUN rekeying operation.
•
Re-key Session Number: The session number of the LUN rekeying operation.
•
Re-key Role: The role of the LUN rekeying operation.
•
Re-key State: The state of a manual LUN rekeying operation. Options are:
-
Read Phase
-
Write Phase
-
Pending
-
Disabled
•
Block Size: The block size used on the LUN.
•
Number of Blocks: The number of blocks written.
•
Current LBA: The Logical Block Address (LBA) of the block that is currently being written.
•
Re-key Completion: The status of the LUN rekeying operation’s progress.
Viewing the progress of manual rekey operations
To monitor the progress of manual rekey operations, complete these steps: