Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1420)

1348 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
VRF management
31
FIGURE 604 Manage VRF dialog box
Adding VRF in an MLX device
To add VRF in an MLX device, perform the following steps.
1. Select Configure > VRF.
The Manage VRF dialog box is displayed.
2. Select Add > IPV4 > Basic or Advanced.
Or
Select Add > IPV6 > Basic or Advanced.
The dialog box displays based on the selection of IPV4 or IPV6 with the Basic or Advanced
configuration.
3. Enter the Parameters value.
Or
Click Import to import the predefined parameter values in a comma-separated value (CSV) file.
4. (Optional) Click Preview to list the commands to be executed with replaced parameters.
5. Click OK.
The deployment details are displayed under the VRF Details pane of the Manage VRF dialog
box.
Deleting VRF in an MLX device
To delete VRF in an MLX device, perform the following steps.
1. Select Configure > VRF.
The Manage VRF dialog box is displayed.
2. Click Delete.