Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 315)

Brocade Network Advisor SAN + IP User Manual 243
53-1003155-01
Areas of responsibility
6
Areas of responsibility
NOTE
You must have User Management Read and Write privileges to view, add, modify, or delete
operational areas of responsibility.
An area of responsibility (AOR) allows you to place Fabrics, Hosts, Products, Product Groups, Port
Groups, and Application products into management groups that can be assigned to an
Management application user. Users can manage only the Fabrics, Hosts, Products, Product
Groups, Port Groups, and Application products in the AOR assigned to them, because only devices
their AOR display in the Product List and Topology Map.
For example, devices 10.10.10.1, 10.10.10.2, and 10.10.14.3 may be placed in AOR Group 1. This
AOR group can then be assigned to UserA. When using the Management application, UserA will be
able to create configurations, generate reports, and perform backups only to entries in AOR Group
1 (which consists of devices 10.10.10.1, 10.10.10.2, and 10.10.14.3).
Creating an AOR
When creating an AOR, you assign devices or groups to that AOR. After you save the AOR, it can be
assigned to one or more user account. Users of those accounts can then view the devices or
groups in their assigned AOR. Users can deploy configurations and payloads only to devices in
assigned AORs.
When you create an AOR, it immediately becomes available in the Users dialog box.
To create an AOR, complete the following steps.
1. Select Server > Users.
The Users dialog box displays.
2. Click Add under the AOR table.
The Add AOR dialog box displays.