Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 483)

Brocade Network Advisor SAN + IP User Manual 411
53-1003155-01
Performance monitors
8
Top Port Encode Error Out monitor
The Top Port Encode Error Out monitor ( Figure 178 ) displays the top ports with encoding errors
outside of frames in a table.
FIGURE 178 Top Port Encode Error Out monitor
The Top Port Encode Error Out monitor includes the following data:
• Severity icon/monitor title — The worst severity of the data based on the error count shown
next to the monitor title.
• Port — The port affected by this monitor.
• Connected_Port_Link (where Connected_Port_Link is Connected Port, Initiator, or Target) —
Displays one of the following:
- Connected Port — The ISL or IFL port on the connected device. Click to launch the switch
port properties dialog box.
- Initiator — The initiator port on the connected device. Click to launch the device properties
dialog box.
- Target — The target port on the connected device. Click to launch the device properties
dialog box.
• Encode Error Out/sec — The number (error rate) of encoding errors outside of frames per
second for the duration specified in the monitor.
• Encode Error Out — The number (error count) of encoding errors outside of frames for the
duration specified in the monitor.
• CRC Errors — The number of CRC errors.
• Link Failures — The number of link failures.
• Invalid Transmissions — The number of invalid transmissions.
• Product — The product affected by this monitor.
• Type — The type of port (for example, U-Port).
• Identifier — The port identifier.
• Port Number — The port number.
• State — The port state (for example, Enabled).