Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1975)

Brocade Network Advisor SAN + IP User Manual 1903
53-1003155-01
Viewing a configuration policy manager report
47

Switch — Check if the product is configured to send events to this server.

Switch — Check if the product is configured to send Upload Failure Data Capture
information to an FTP server.

Switch - Check for SSH (secure Telnet) configuration. This check provides the following
additional detail for this check:
- SSH Status — Whether SSH is enabled or disabled on the product.
- Telnet Status — Whether Telnet is enabled or disabled on the product.

Switch - Check for SNMPv3 (secure SNMP) configuration. This check provides the
following additional detail for this check:
- SNMPv3 Status — Whether SNMPv3 is enabled or disabled on the product.
- SNMP Status — Whether SNMP is enabled or disabled on the product.

Switch - Check for MAPS actions enabled (SAN only). This check provides the following
details:
- RAS Log Event — Whether the RAS log event action is enabled or disabled on the
switch.
- Port Decommission — Whether the Port Decommission event action is enabled or
disabled on the switch
- SNMP Trap — Whether the SNMP Trap event action is enabled or disabled on the
switch.
- Fence — Whether the Fence event action is enabled or disabled on the switch.
- E-mail — Whether the e-mail event action is enabled or disabled on the switch.
- SFP Status Marginal — Whether the SFP Status Marginal event action is enabled
or disabled on the switch.
- Switch Status Marginal — Whether the Switch Status Marginal event action is
enabled or disabled on the switch.
- Switch Status Critical — Whether the Switch Status Critical event action is enabled
or disabled on the switch.

Switch - Check for VLAN configuration matches for each connection (IP only). This
check provides the following additional detail for this check:
- Local Switch Port — Name of the local switch port.
- Local VLANs — Local VLAN number.
- Status — Whether the configurations matched (Passed) or did not match (Failed).
- Remote VLANs — Remote VLAN number.
- Remote Port — Name of the remote switch port.
- Remote Switch — Name and IP address of the remote switch.

Configuration Rule Checks — Switch checks provide the following information for each
selected check:
- Block/Condition Name — Name of the block or condition.
- Matched Block — Name of the matched block.
- Status — Whether the configurations matched (Passed) or did not match (Failed).
- Failed Condition — Name of the failed condition.
- Match/Not Match — Whether the configurations matched (Match) or did not
match (Not Match).