Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1443)

Brocade Network Advisor SAN + IP User Manual 1371
53-1003155-01
Change tracking
32
SWCH-1007 LOG Indicates that the specified switch port is disabled due to the reason
displayed in the message.
UDLD-1000 LOG Indicates that the UniDirectional Link Detection (UDLD) protocol is enabled
globally.
UDLD-1001 LOG Indicates that the UniDirectional Link Detection (UDLD) protocol is disabled
globally.
UDLD-1002 LOG Indicates that the UniDirectional Link Detection (UDLD) Hello time has been
changed.
UDLD-1003 LOG Indicates that the UniDirectional Link Detection (UDLD) timeout multiplier
value has been changed.
UDLD-1004 LOG Indicates that the UniDirectional Link Detection (UDLD) protocol is enabled on
the specified interface.
UDLD-1005 LOG Indicates that the UniDirectional Link Detection (UDLD) protocol is disabled on
the specified interface.
UDLD-1006 LOG Indicates that the specified interface has been detected as a unidirectional
link. The interface is blocked.
VC-1000 LOG Indicates that a new vCenter configuration was added.
VC-1001 LOG Indicates that the specified vCenter configuration has been updated.
VC-1002 LOG Indicates that the specified vCenter configuration has been deleted.
VC-1003 LOG Indicates that the specified vCenter configuration has been activated.
VC-1004 LOG Indicates that the specified vCenter configuration has been deactivated.
VC-1006 LOG Indicates that the periodic discovery timer interval has been changed for the
specified vCenter.
VC-1007 LOG Indicates that the vCenter ignore invalid discovery cycle count has been
changed.
VC-1010 LOG Indicates that the vCenter ignore invalid discovery cycle count has been
changed to "always".
VCS-1001 LOG Indicates that the VCS cluster has been created due to the initial VCS
logical-chassis being enabled on two or more nodes where a VCS cluster of
the same VCS ID did not exist before.
VCS-1003 LOG Indicates that a logical-chassis node has been added to the VCS cluster. The
node was added because the VCS logical-chassis is enabled on a node that
was not a member of the VCS cluster.
VCS-1005 LOG Indicates that the logical-chassis node has gone offline and returned online
without any configuration changes.
VCS-1007 LOG Indicates that VCS is disabled on the node that was part of a VCS cluster.
VCS-1009 LOG Indicates that the heartbeat loss to a logical-chassis node occurred because
the node was reloaded or all interswitch links (ISLs) to the node are down.
ZONE-1022 LOG The effective configuration has changed to <Effective configuration name>.
ZONE-1023 LOG Switch connected to port (<port number>) is busy. Retrying zone merge.
ZONE-1024 LOG Indicates that the cfgSave command has completed successfully.
ZONE-1034 LOG A new zone database file is created.
TABLE 128 Configuration change events for Adaptive backup (Continued)
Message ID Type Description