Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1988)

1916 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
SNMP traps
48
FIGURE 849 SNMP Trap Forwarding dialog box
Adding a trap destination
The Add Trap Destination dialog box allows you to configure destinations for forwarding SNMP
traps.
To add a trap destination, complete the following steps.
1. Select Monitor > SNMP Setup > Trap Forwarding.
The SNMP Trap Forwarding dialog box, shown in Figure 849 , displays.
2. Select the Enable trap forwarding check box.