Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1760)

1688 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
IP sFlow configuration
43
IP sFlow configuration
The Management application supports the creation of sFlow reports to capture traffic data.
Configuring sFlow
You can use the sFlow configuration wizard to configure an sFlow data collector and a destination
for the sFlow data collector.
1. Select Monitor > Traffic Analysis > Configure sFlow.
The Interface Payload - sFlow Configuration dialog box displays.
FIGURE 768 Interface Payload - sFlow Configuration dialog box
Under SFlow Configuration Selection, there are two check boxes:
• sFlow Settings - Allows you to enable or disable sFlow, and allows you to configure traffic
sampling rates.
• sFlow Destination - Allows you to add or delete sFlow collector entries in the device.
Select both if you are adding an sFlow data collector. If you are enabling or disabling sFlow of
modifying traffic sampling rates, you may select only sFlow Settings.