Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1384)

1312 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Activating an Allow/Prohibit Matrix configuration
30
FIGURE 580 Save As/Duplicate dialog box
4. Enter a name for the configuration.
5. Enter a description for the configuration.
6. Select the check box for the device to which you want to save the configuration in the Selected
Switch list.
7. Click OK.
A message displays stating that the outstanding port configuration is discarded when copying
a configuration from the switch with more ports to a switch with fewer ports and vice versa.
Click OK to close the message.
The saved configuration displays in the Available Switches table under the selected switch. To
edit this configuration, refer to
“Configuring an Allow/Prohibit Matrix” on page 1307 or
“Configuring an Allow/Prohibit Matrix manually” on page 1308.
Activating an Allow/Prohibit Matrix configuration
You must have an active zone configuration before you can activate an Allow/Prohibit Matrix
configuration.
1. Select Configure > Allow/Prohibit Matrix.
The Configure Allow/Prohibit Matrix dialog box displays.
2. Select the Allow/Prohibit Matrix configuration you want to activate.
You can do this by expanding the view for the switch under Available Switches and selecting a
configuration, or you may select the matrix under Allow/Prohibit Matrix.
3. Click Activate.
A confirmation message displays, as shown in Figure 581 on page 1313.