Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1460)

1388 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Creating a payload configuration
33
FIGURE 621 Configuration dialog box - Deployment Targets pane
6. In the Available Targets list, select the products, product groups, and IP subnets to which the
payload configuration is to be deployed.
• To select a target, expand the entry to display the entries under it, click the target in the
Available Targets list, and click the right-arrow button to move it to the Selected Targets
list.
If the target is not on the list, run the discovery process.
NOTE
The Deployment Targets pane of the Configuration wizard does not include VCS devices
when launched from the Configuration Wizard command on the Configure menu.
• To remove a target, select it in the Selected Targets list and click the left arrow button to
move it back to the Available Targets list.
7. Click Next.
The Deployment Properties pane displays, as shown in Figure 622 on page 1389.