Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1770)

1698 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
IP sFlow configuration
43
18. Examine each listed item and decide the following:
Do you want to enter values in the field, or be prompted to enter the value when running the
report? If you want to be prompted, select the Prompt check box.
If you do not chose the Prompt check box, you may enter any of the following in the fields
provided:
- Source Subnet Bits - Enter the source subnet of the route.
- Destination Subnet Bits - Enter the destination subnet of the route.
- Local AS - Enter the local AS number.
- Source AS - Enter the destination AS number.
- Source Peer AS -Enter a source peer AS number.
- AS Paths - Enter an AS path number.
- Flow Label - Enter a flow label.
19. Select the Time Settings tab.
FIGURE 777 Add Report Definitions dialog box, Time Settings tab
20. Select Relative time if the you want to retrieve information relative to a time range, or Absolute
time if you want to run the report at a specific date and hour.
- If you select Relative time, use the Range selector to
- If you select Absolute time, use the Start Date and Start Time selectors to set the time that
data collection begins, and the End Date and End Time selectors to set the time when data
collection ends.