Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 910
838
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Switch, port, and LAG deployment
20
NOTE
On the Deploy to Ports dialog box, you can write port configurations to the switch by enabling
the check box at the bottom of the dialog box.
For LAGs:
•
LAG attributes (Interface Mode, etc.)
•
QoS, DCB Map / Traffic Class Map
•
LLDP Profiles
9. Click to move the available targets selected for configuration deployment to the Selected
Targets list.
10. Click OK.
The Deployment Status dialog box launches.
11. Click Start on the Deployment Status dialog box to save the changes to the selected devices.
12. Click Close to close the Deployment Status dialog box.
Source to target switch Fabric OS version compatibility for deployment
lists the restrictions that exist when deploying source switches to target switches.
TABLE 90
Source to target switch Fabric OS version compatibility
Source Fabric OS version and device
Target Fabric OS version supported
Comments
Fabric OS DCB switch and
FCOE10-24 DCB blade with Fabric
OS version 6.4.2 or earlier.
Allows Fabric OS DCB switch and
FCOE10-24 DCB blade with Fabric
OS version 6.4.2 or earlier.
Excludes Fabric OS Converged 10
Gbe switch module for IBM
BladeCenter with Fabric OS
6.3.1_cee, Fabric OS 6.4.1_fcoe,
and Fabric OS 6.3.1_dcb.
You cannot copy legacy
configurations to Fabric OS version
7.0 switches, because these
switches support FCoE maps and
can have only one default DCB map.
Legacy Fabric OS switches,
however, can have more than one
default map.
Fabric OS FCOE10-24 DCB blade
with Fabric OS 6.4.1_fcoe
Allows FCOE10-24 DCB blade with
Fabric OS 6.4.1_fcoe or Fabric OS
7.0.0.
Allows Fabric OS Converged 10 Gbe
switch module for IBM BladeCenter
with Fabric OS 6.3.1_cee or Fabric
OS 6.3.1_dcb.
Excludes Fabric OS DCB switch and
FCOE10-24 DCB blade with Fabric
OS 6.4.2 or earlier.
Both the source and the target
support only one default DCB map.
You can copy QoS, LLDP, and
802.1x configurations from the
source to the target.
Fabric OS DCB switch
FCOE10-24 DCB blade with Fabric
OS 7.0.
Allows Fabric OS DCB switch and
FCOE10-24 DCB blade with Fabric
OS 7.0.0.
Excludes all others.
VLAN classifiers are supported, but
the FCoE map is not supported on
Fabric OS 7.0.0.