Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 152)

82 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Default IP user credentials
3
6. Edit the unique label to identify the credentials in the Display Label field.
This label can be from 1 through 200 characters long, case sensitive, and allows all printable
ASCII characters.
7. Edit the user name in the User ID field.
8. Edit the user password in the Password field.
9. Click the right arrow button.
10. If the devices use multiple user names and passwords, use the Up or Down buttons to place
the most commonly used at the top of the Login Prompt List to make discovery run more
efficiently.
11. Click Apply to save your work.
12. Click Close to close the Discover Setup - IP dialog box.
13. Click Yes on the confirmation message.
Editing enable super user credentials
To edit an enable super user, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Global Settings tab.
3. Click the Default Passwords tab.
4. Select Enable Super User from the Credential Type list.
5. Select the user credential entry you want to edit in the Login Prompt List and click the left
arrow button.
The selected credentials display in the Add/edit Login Prompt area.
6. Edit the unique label to identify the credentials in the Display Label field.
This label can be from 1 through 200 characters long, case sensitive, and allows all printable
ASCII characters.
7. Edit the super user password in the Password field.
8. Click the right arrow button.
9. If the devices use multiple user names and passwords, use the Up or Down buttons to place
the most commonly used at the top of the Login Prompt List to make discovery run more
efficiently.
10. Click Apply to save your work.
11. Click Close to close the Discover Setup - IP dialog box.
12. Click Yes on the confirmation message.