Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1503)

Brocade Network Advisor SAN + IP User Manual 1431
53-1003155-01
Software image management
35
You can change the default schedule from the Backup Scheduler by performing the following tasks.
1. Click the IP tab.
2. From the Management application menu bar, select Configure > Configuration > Schedule
Backup.
or
Right-click Configuration > Schedule Backup.
The Schedule Backup dialog box displays, as shown in Figure 636 .
FIGURE 636 Schedule Backup dialog box
3. Select the automatic software image backup task from the list, and click Edit.
The Edit Automatic Software Image Backup dialog box displays, as shown in Figure 637 .
FIGURE 637 Edit Automatic Software Image Backup dialog box
4. Disable the scheduled backup or modify the frequency and time.
Refer to “Scheduling a configuration backup” on page 1379 for information about how to
schedule a configuration backup.
5. Click OK.
Deploying software images to products
The Management application stores previously imported software images. These software images
can be placed in a software image payload and deployed to products using the Firmware
Management dialog box.
For a HyperEdge stack, you must deploy the ICX 6610 and ICX 6450 software images to the active
master unit separately. Make sure that both software images have the same software image
version. When both software image upgrades are complete, reload the HyperEdge stack. The
master unit upgrades the software images to the appropriate member units.
Deleting software images from the Management application
If a software image stored in the Management application must be deleted, perform the following
steps.