Master log and switch console troubleshooting, Names troubleshooting, Master log and switch console troubleshooting 7 – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 2319: Names troubleshooting 7
Brocade Network Advisor SAN + IP User Manual
2247
53-1003155-01
Master Log and Switch Console troubleshooting
H
Master Log and Switch Console troubleshooting
The following section states a possible issue and the recommended solution for switch console
errors.
Names troubleshooting
The following section states a possible issue and the recommended solution for names errors.
Problem
Resolution
Too many login and log messages received on
switch console and and Master Log due to lazy
polling.
NOTE: This setting cannot be disabled for DCB switches.
To disable lazy polling, complete the following steps.
1
Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2
Click the Global Settings tab.
3
Click the Preferences tab.
4
Clear the Enable lazy polling check box.
5
Click Apply to save your work.
6
Click Close to close the Discover Setup - IP dialog box.
7
Click Yes on the confirmation message.
Problem
Resolution
Duplicate name error.
If you configured the Management application to only allow unique names and you try to
use a name that already exists in the fabric. You can enter a different name for the device
or search for the duplicate name using one of the following procedures:
•
“Searching for a device by name”
on page 185 in the Configure Names dialog box
•
“Searching for a device by WWN”
on page 186 in the Configure Names dialog box
•