Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1664
1592
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
FC troubleshooting
42
ATTENTION
If you run more than one test per slot, the result may go wrong or the test may fail.
To run a diagnostic port test, complete the following steps.
1. Select Monitor > Troubleshooting > FC > Diagnostic Port Test.
The Diagnostic Port Test dialog box displays.
2. Select the ports for which you want to run a diagnostic port test from the Available Ports table.
You can only run 10 diagnostic port tests at a time. If you select more than 10 ports, the
Management application runs the first 10 diagnostic port tests and queues the rest. When the
first test is completed, the next test in the queue begins and so on until all tests are completed.
3. Click the right arrow button to move the ports to the Selected Ports table.
4. To configure parameters for the link traffic test, select the ports for which you want to
configure link traffic test in the Selected Ports table and click Link Traffic Test.
“Configuring link traffic test parameters”
5. Click Start.
The Management application performs the following operations to enable diagnostic mode on
the selected ports:
1. Disable the source port.
2. Disable the destination port.
3. Enable the diagnostic mode on source E-port.
4. Enable the diagnostic mode on destination E-port.
5. Enable the source port.
6. Enable the destination port.
The following tests are performed on the selected ports:
The following tests are performed on the selected ports:
•
Electrical loopback (16 Gbps only)
•
Optical loopback (16 Gbps only)
TABLE 136
D-Port test support matrix
D-Ports Tests
Fabric OS 7.0
Fabric OS 7.1
HBA driver 3.2
E-Port
E-Port
F-Port
AG N-Port
ICL-Port
Electrical Test
Supported
Supported
Supported
Supported
Not supported
Supported
Optical Test
Supported
Supported
Supported
Supported
Not supported
Not supported
Link
Traffic
Test
Configuration
Not supported
Supported
Supported
Supported
Supported
Not supported
Test
Supported
Supported
Supported
Supported
Supported
Not supported
Link Distance
Supported
Supported
Supported
Supported
Supported
Not supported
Link Measurement
Not supported
Not supported
Supported
Supported
Supported
Not supported