Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 965)

Brocade Network Advisor SAN + IP User Manual 893
53-1003155-01
Layer 2 access control list management
22
2. Review the Layer 2 ACL configuration details.
• ACLs list — Displays the ACLs to be deployed for this configuration. The ACLs list includes
the following details:

Operation — Displays the ACL operation (no action) during deployment.

Name — The name of the ACL.

Type — The ACL type. Options include: Extended or Standard.
• Details of Selected ACLs list — Displays the details of the ACL selected in the ACLs list. The
Details of Selected ACLs table includes the following details:

Sequence — The Layer 2 ACL entry sequence number.

Action — Whether the ACL permits or denies traffic.

Source — The source MAC address on which the ACL filters traffic.

Destination (Extended only) — The destination MAC address on which the ACL filters
the traffic.

Count — Whether count is enabled or disabled.

Ether Type (Extended only) — The Ethernet protocol. Values include ARP, FCoE, IPv4, or
Custom.
• Add button — Displays; however, is not available.
• Edit button — Displays; however, is not available.
• Duplicate button — Displays; however, is not available.
• Delete button — Displays; however, is not available.
3. Click OK to close on the Device_Name - Layer 2 ACL Configuration dialog box.
Viewing Layer 2 ACL configuration on an interface (Network OS)
NOTE
You cannot configure a Layer 2 ACL using the Management application. You must configure the
Layer 2 ACL through the Network OS CLI (refer to the Network OS Command Reference).
To view Layer 2 ACL configurations on an interface, complete the following steps.
1. Select the fabric, a node in the fabric, or a standalone device and select Configure > Security >
Layer 2 ACL > Port.
2. Select a port in the Available Ports list and click the right arrow button to move it to the
Selected Port list.
3. Click OK on the Port Selection - Layer 2 ACL dialog box.
The Device/Fabric_Name - Port_Number - Layer 2 ACL Configuration dialog box displays.
Depending on the Display Label you choose, the Device/Fabric_Name is the name of the
device or fabric, the IP address of the device or fabric, or the name and IP address of the
device or fabric.