Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 164)

94 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
IP discovery profiles
3
1. Select Subnet from the Entry Type list.
FIGURE 28 Include Subnet
2. Enter the IP address in the IP Address field.
3. Enter the subnet mask in the Subnet Mask field.
4. To exclude an address range using the Subnet format, refer to “Excluding subnet addresses”
on page 95.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 92.
Adding IP addresses
To add an IP address range (IPv4 and IPv6), complete the following steps.
1. Select IP Address from the Entry Type list.
FIGURE 29 Include Address Range
2. Enter the first IP address in the range in the first IP Address field.
3. Enter the last IP address in the range in the second IP Address field.
4. To exclude an address range using the IP Address format, refer to “Excluding IP addresses” on
page 96.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 92.
Excluding CIDR subnet addresses
To exclude CIDR subnet addresses (IPv4 and IPv6), complete the following steps.