Dell Emulex Family of Adapters - Manual (Page 95)

OneCommand™ Manager Application P010066-01A Rev. A
5. Configuring Discovery
Configuring iSCSI Target Discovery
95
Output similar to the following will be returned.
emulex-cim-provider
10.0.514.6-01
Emulex VMwareAccepted
2013-06-10
4. Choose the refresh rate settings you want to apply.
5. Click OK to apply your changes. Click Defaults to return the discovery properties
to their default settings.
Configuring iSCSI Target Discovery
The iSCSI Target Discovery tab allows you to configure iSCSI target discovery related
parameters.
Figure 5-6 iSCSI Target Discovery Tab
To display the iSCSI Target Discovery tab:
1. From the discovery-tree, select the iSCSI port whose discovery settings you want to
configure.
2. Select the iSCSI Target Discovery tab.
Target Discovery Field Definitions

Target Portals – The Target Portals table contains all target portals that are
queried for targets. Depending on the SAN setup, the contents of this table may
be a subset of the available target portals, or it could contain the full set of target
portals for all iSCSI targets.

Targets – The Targets table contains all currently discovered targets. Targets in
this table come from one of three possible sources: