Dell Emulex Family of Adapters - Manual (Page 1797)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
Appendix H. Configuring PXE Boot for NIC on Dell OCe14000-based Systems
Setting Up a PXE Bootable Network
1797
If these conditions are not met, you may be able to configure more than eight functions,
but only up to eight functions will be running and discovered after a reboot.
To enable NParEP:
1. From Controller Configuration screen (Figure H-2), highlight the NParEP Support
menu item.
2. Select Enabled and press to save.
When NParEp is enabled, additional functions are displayed on the Partition List
screen.
Figure H-7 Partition(s) List Screen When NParEP is Enabled
See “Configuring NPar” on page 1794 for more information on configuring the
additional functions.
Configuring Boot Options
To view the Boot Configuration screen:
1. From Port Menu (Figure H-4), select 2. Boot Configuration and press . The
Boot Configuration screen appears.
Figure H-8 Boot Configuration Screen
From the Boot Configuration screen, you can perform the following tasks:

Configure PXE boot support – see “Configuring PXE Boot Support” on
page 1798 for instructions.

Configure the Hide Setup prompt – see “Configuring the Hide Setup Prompt”
on page 1798 for instructions.

Configure the banner message timeout – see “Configuring the Banner Message
Timeout” on page 1798 for instructions.