Dell Emulex Family of Adapters - Manual (Page 225)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
OCe14000-Series Adapters
225
7. The LPVIDs will be set to 0. You must assign a valid LPVID to the NIC channel.
Note: These rules create the default settings for the channels. You can change these
settings before saving them.
IBM MultiChannel Configuration View
For IBM multichannel configuration, there are three different multichannel types
available: vNIC, SIMode, and UFP. When you check the MultiChannel radio button,
the Adapter Configuration tab looks like the following:
Figure 8-79 MultiChannel View (showing multichannel type drop-down)
A MultiChannel Type pull-down menu is available to select the type of multichannel
configuration on the adapter. The contents of the Channel Configuration table depend
upon the selected multichannel type.
Note: When IBM MultiChannel is enabled, RoCE cannot be configured on any
function.
Note: For IBM multichannel, only a maximum of four channels per port can be
configured even on one and two port adapters.