Dell Emulex Family of Adapters - Manual (Page 646)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
3. Configuration
NIC Driver Configuration
646
Note: NParEP is only available when NPar mode is activated on
OCe14000-series adapters. See “Using NParEP” on page 649.

Reset the adapter to the factory default settings using the Factory Default
button.

Use the Port tab to view the available ports on the adapter.

Configure a protocol to run on each partition on the ports.

Configure the minimum and maximum bandwidth for each partition on the
ports.
Open Device Manager by using one of the following options:

Click Start> Control Panel>System and click the Device Manager hyperlink.

Click Start>Run, then type and click OK.
The Windows Device Manager is displayed (see Figure 3-1).
Select one of the Emulex NIC adapters, right-click on it, and select Properties. The NIC
adapter driver Properties dialog box opens. Click on the Multichannel tab.
Figure 3-19 The Multichannel Property Page with NPar Disabled
Multichannel Property Page Field Definitions

Mode — lists all possible multichannel technologies available on the selected
adapter. Use it to control multichannel mode selection for the entire adapter. If