Dell Emulex Family of Adapters - Manual (Page 708)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
Appendix A. Error and Event Log Information
NIC Error and Event Logs
708
0x0014/20 Error Failed to read registry
configuration. The registry is corrupted. Reinstall
the driver and/or operating system.
0x0013/19 Error Resource conflict. The operating system failed to
allocate resources for the device.
Check low memory conditions and
operating system hardware resource
conflicts.
0x0012/18 Error Failed to enable bus mastering. Verify that the BIOS allows bus
mastering and that no resource
conflicts exist.
0x0011/17 Error The driver is incompatible with the
device. The driver is loaded on the incorrect
hardware device. Verify that the
correct driver is installed.
0x0010/16 Warning The network driver was reset. This may indicate a system hang or
hardware issue. Verify other system
devices are working properly.
0x000c/12 Informational The Ethernet link is down. This message is informational.
0x000b/11 Informational The Ethernet link is up. This message is informational.
0x000a/10 Error The network device detected an
error. A hardware error occurred. Verify
that the firmware flash image is not
corrupted. Contact Emulex Technical
Support.
0x0009/9 Error Failed to register interrupt service
routine. This is an NDIS error. Verify that
hardware resource conflicts do not
exist.
0x0008/8 Error Failed to get TCP offload handlers. This is an NDIS error. Verify the NDIS
version is valid for the driver.
0x0007/7 Warning A memory allocation failure
occurred during driver load.
Performance may be reduced. This warning occurred due to a
failed memory allocation. Check low
memory conditions. Use a smaller
MTU or disable TCP offload to
reduce driver memory requirements.
0x0006/6 Error Driver load failed due to memory
allocation failure This failure occurred due to a failed
memory allocation in the driver.
Check low memory conditions.
0x0005/5 Error Failed to register scatter gather
DMA. This failure occurred due to a failed
memory allocation in the operating
system. Check low memory
conditions.
0x0004/4 Error Failed to map device registers. This failure occurred due to a failed
memory allocation in the operating
system. Check low memory
conditions.
Table A-13 NIC Event Log Entries (Continued)
Message ID
Hexadecimal/
Decimal Severity Message Recommended Resolution