Dell Emulex Family of Adapters User Manual
Page 909
Emulex Drivers Version 10.2 for Linux User Manual
P010081-01A Rev. A
4. Troubleshooting
Log Messages
909
0449: lpfc_%attr attribute cannot be initialized to %d, allowed range is [%min,
%max]
The sysfs attribute value written exceeds attribute range.
Data:
(1) attribute name (2) value written (3) minimum value (3) maximum value
Severity: Error
Log:
Always
Action:
Write a value within the supported range.
0450: lpfc_%attr attribute cannot be set to %d, allowed range is [%min, %max]
The sysfs attribute value written exceeds attribute range.
Data:
(1) attribute name (2) value written (3) minimum value (3) maximum value
Severity: Error
Log:
Always
Action:
Write a value within the supported range.
0451: Enable interrupt handler failed
The driver attempted to register the HBA interrupt service routine with the host operating system,
but failed.
Data:
None
Severity: Error
Log:
Always
Action:
This error could indicate a hardware or driver issue. If this issue persists, report the error
to Technical Support.
0453: Adapter failed to init, mbxCmd
Adapter initialization failed when issuing a READ_CONFIG mailbox command.
Data:
None
Severity: Error
Log:
Always
Action:
This error could indicate a hardware or firmware issue. If this issue persists, report the
error to Technical Support.
0454: Adapter failed to init, mbxCmd
Adapter initialization failed when issuing an INIT_LINK mailbox command.
Data:
None
Severity: Error
Log:
Always
Action:
This error could indicate a hardware or firmware issue. If this issue persists, report the
error to Technical Support.
0456: Adapter failed to issue ASYNCEVT_ENABLE mbox status x%x
The mailbox command to enable an asynchronous event notification failed.
Data:
None
Severity: Error
Log:
LOG_INIT
Action:
Ensure the adapter firmware is current. Reload the driver.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)