Dell Emulex Family of Adapters - Manual (Page 1459)

Boot for the Fibre Channel Protocol User Manual P010096-01A Rev. A
6. EFIBoot
Reset to Default Values
1459
Reset to Default Values
The EFI utility enables you to reset EFI boot parameter to their factory default settings.
These defaults are listed in Table 6-1.
Table 6-1 Adapter Defaults
Parameter Default Valid Values
Enable/Disable BIOS Disabled Enabled
Disabled
ALPA Value 0x00 Fibre See ALPA reference table
Device Path FC Fibre Channel (FC)
SCSI
PLOGI Retry Timer Disabled Disabled
50 msec
100 msec
200 msec
Boot Target Scan Boot path from
NVRAM targets Boot path from NVRAM targets
Boot path discovered targets
Do not create boot path
Max LUNs Setting 256 0–4096
Topology Auto (start FC-AL) Auto (start FC-AL)
Point-to-Point
Auto (start Point-to-Point)
FC-AL
Delay Device Discovery 0000 0000–0255
Link Speed 0 0 = Auto select
1 = 1 Gb/s
2 = 2 Gb/s
4 = 4 Gb/s
8 = 8 Gb/s
16 = 16 Gb/s