Dell Emulex Family of Adapters - Manual (Page 451)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
Appendix A. OneCommand Manager Error Messages
451
ERROR: <181>: Authentication:
Insufficient credentials
All The specified username and
password are valid and the user is
a member of an OneCommand
Manager group, however the
OneCommand Manager group does
not have sufficient privileges to
execute the specified command.
See “OneCommand Manager
Secure Management” on page 296
for more information.
ERROR: <183>: Secure Mgmt: user
not a member of OCM group
All The specified username and
password could be authenticated,
but the user is not a member of an
OneCommand Manager group. See
“OneCommand Manager Secure
Management” on page 296 for
more information.
ERROR: <206>: Authentication
Failed
All This indicates either a valid
username, but invalid password,
or a general user authentication
error. See “OneCommand Manager
Secure Management” on page 296
for more information.
ERROR: <222>: DCB not available
GetDCBParams
SetDCBParam
GetPGInfo
SetDCBPriority
SetCnaPGBW These commands are not available
on OCe11101-EM/EX or
OCe11102-EM/EX adapters. See
“DCB Commands” on page 348.
ERROR: <251>: Hardware or firmware
does not support command.
SRIOVEnable
UmcEnable
UmcGetParams
UmcSetBW
UmcSetLPVID
SetPhyPortSpeed These commands are not available
on OCe11101-EM/EX or
OCe11102-EM/EX adapters. See
“SRIOVEnable” on page 405, and
“UMC Commands” on page 439.
Error: <431> Cable length required
for force mode and interface type
SetPhyPortSpeed This error is displayed when a
length value is not included when
the mode is set to 2.
Example:
hbacmd setphyportspeed
00-00-c9-a9-41-88 2 100Mb
See “Examples” on page 335.
Table A-1 OneCommand Manager Error Messages (Continued)
Error Message Command(s) Description