Dell Emulex Family of Adapters - Manual (Page 1659)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
11. Configuring UEFI for Ethernet
Identifying a Port
1659
7. Use the arrow keys to select the flash file and press to begin the update
process. It takes about two minutes to complete.
Figure 11-28 Emulex Flash Update Utility, Flash Updating
Note: This firmware flash procedure only flashes the physical interface which was
selected in the HII menu. All Emulex adapters must contain the same
firmware version to function properly. The above procedure should be
repeated for each physical interface installed in the system before
proceeding to the next step.
8. Reset the system. The latest version information for the adapter is displayed in the
Emulex NIC Selection screen (Figure 11-1).
Identifying a Port
To physically identify a port on the Emulex NIC Selection screen, select Port
Identification and press . The LEDs on your controller start blinking indicating
the selected port.
Note: Not all controllers have LEDs that are visible externally. If you are using an
add-in card in a blade server environment, the port identification or beaconing
capability does not work.