Dell Emulex Family of Adapters - Manual (Page 1364)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1364
h= listvports
Description
This command lists virtual ports on the specified physical port. Leaving the physical
WWPN parameter blank lists all virtual ports on all manageable hosts that support
virtual ports.
Parameters
loadlist
Note: Loadlist is not supported for UCNAs.
Syntax
elxvcpcmd.exe v= u= p=
h= loadlist
Description
This command shows the flash parameters for a given FC port.
Parameters
loopbacktest
Syntax
elxvcpcmd.exe v= u= p=
h= loopbacktest [Pattern]
Description
This command is used to run a loopback test on a given FC, FCoE, NIC or iSCSI port.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.