Dell Emulex Family of Adapters - Manual (Page 1578)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
6. Using the FCoE Boot BIOS Utility for x86 and x64 Architectures
Navigating the FCoE BIOS Utility
1578
6. Using the FCoE Boot BIOS Utility for x86 and
x64 Architectures
Before using the FCoE BIOS utility, ensure that the boot code is loaded and enabled on
the adapter as described in “Updating and Enabling Boot Code” on page 1595.
Note: This section reflects the most recent release of the FCoE BIOS utility. Some
selections may not be available if you are using an older version of the utility.
Note: After exiting the FCoE BIOS configuration utility, the system will reboot
whether or not any changes have been made.
Navigating the FCoE BIOS Utility
The FCoE BIOS utility has menus and configuration screens. Use the following
methods to navigate them:

Press the up/down arrows on your keyboard to move through and select menu
options or configuration fields. When multiple adapters are listed, use the
up/down arrows to scroll to the additional adapters.

Press to scroll to the previous page.

Press to scroll to the next page.

Press to select a menu option, to select a changed value, to select a row
in a configuration screen or to change a configuration default.

Press to go back to the previous menu.
Starting the FCoE BIOS Utility
Note: Links must be established before entering the FCoE BIOS utility; otherwise, you
will receive an error message.
To start the FCoE BIOS utility:
1. Turn on the computer and press and hold down or and press
immediately (within five seconds) when the Emulex bootup message to start the
FCoE BIOS utility is displayed. An adapter listing is displayed (Figure 6-1).
Note: If the bootup message does not appear, you must enable x86 BootBIOS. For
more information, see “Updating and Enabling Boot Code” on page 1595.