Dell Emulex Family of Adapters - Manual (Page 1630)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
11. Configuring UEFI for Ethernet
Starting the Emulex NIC Configuration Utility
1630
Configuring iBFT
Note: Boot mode must be set to Disable to access the iBFT Configuration menu.
iSCSI configuration through the NIC interface (iBFT) is exactly the same as normal
iSCSI configuration except it is performed through the NIC interface. In order for this to
occur, you must use the operating system’s NIC driver and an iBFT-aware operating
system.
To configure iBFT:
1. On the Emulex NIC Selection Screen (Figure 11-2), select iBFT Configuration and
press .
The iBFT Configuration screen appears.
Figure 11-4 iBFT Configuration Screen
The iBFT Configuration screen enables you to perform the following tasks:

Edit the iSCSI initiator name

Enable multipath I/O

Configure the CHAP authentication mode

Configure the network settings

Configure the primary or secondary targets
Once you have completed the iBFT configuration, you must save your changes.
To save changes:
1. Press to return to the NIC Selection Menu.
2. Select Save Changes and press .