beautypg.com

Dell Emulex Family of Adapters User Manual

Page 1134

background image

Emulex Drivers Version 10.2 for VMware ESXi User Manual

P010087-01A Rev. A

4. Troubleshooting

Troubleshooting the NIC Driver

1134

Warning

WARNING: Found a OneConnect

card in Gen x PCI-e slot.

Should be in Gen 2, x8 slot for

best performance

The adapter is an x8, Gen2 PCI-e
device. For best performance, the
adapter should be installed in a
Gen2 PCI-e slot 8 or 16 channels
wide. The driver displays this
warning if it finds the device in a
slower or narrower PCI-e slot. The
device continues to work with
reduced performance.

Warning

Command to get pause frame

settings failed

The firmware command to get PAUSE
settings failed.

Warning

Command to set pause frame

settings failed

The firmware command to change
PAUSE settings failed.

Warning

Command to apply MAC address

filter failed

The driver could not set the MAC
address filter on the hardware. The
device continues to work. There may
be an impact on the performance.

Warning

Command to delete MAC address

filter failed

The firmware command to delete a
MAC address filter failed. The device
should continue to work.

Warning

Unable to get Firmware Version

The command to get the firmware
revision number failed. The version
number is not shown. The device
will continue to work.

Warning

Did not receive completions for

all TX requests

While the driver was unloading,
some outstanding transmit requests
were found. This is an indication
that the hardware is not functioning
properly.

Warning

Failed to register char device

Could not create the char device
used for certain management
functions. The driver will continue
to work. You may not be able to use
HBACMD to interact with the device.

Warning

alloc_skb failed. Try

increasing netPktHeapMaxSize

Could not allocate the skb structure
to send a frame received from the
network to the operating system.
This is a transient failure that can be
ignored. If this message appears
continually, you may need to
allocate more memory to the
network heap. For example, to
increase the heap size to 128MB,
run:
# esxcfg-advcfg -k 128
netPktHeapMaxSize

Table 4-5 ESXi Server NIC Event Log Entries (Continued)

Severity

Displayed Message

Description