Dell Emulex Family of Adapters - Manual (Page 938)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
938
1825: Vport Created.
This message is displayed to indicate that a port was created in the system. It is displayed at this
level to ensure it is always appears at all log levels.
Data: None
Severity: Error
Log:
LOG_VPORT verbose
Action: No action, informational.
1826: Vport Disabled.
The port had to be disabled in the system.
Data: None
Severity: Error
Log:
LOG_VPORT verbose
Action: No action, informational.
1827: Vport Enabled
The port had to be enabled after possible recovery from some errors.
Data: None
Severity: Error
Log:
LOG_VPORT verbose
Action: No action, informational.
1828: Vport Deleted
A Vport was deleted.
Data: None
Severity: Error
Log:
LOG_VPORT verbose
Action: No action, informational.
1829: CT command failed to delete objects on fabric.
A command issued to the fabric to delete an associated resource for an object, such as for a port,
failed.
Data: None
Severity: Error
Log:
LOG_VPORT verbose
Action: Software driver error. If this issue persists, report these errors to Technical Support.
1830: Signal aborted mbxCmd
A pending mailbox command was aborted because the thread received a signal.
Data: None
Severity: Error
Log:
LOG_VPORT verbose
Action: You should retry the attempted command.
1831: Create VPORT Interrupted
The port creation process was unexpectedly interrupted at a critical time and the operation was
unsuccessful.
Data: None
Severity: Error
Log:
LOG_VPORT verbose
Action: The process was interrupted while creating a VPort. Retry the command.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)