Dell Emulex Family of Adapters - Manual (Page 1068)

Emulex Drivers Version 10.2 for VMware ESXi User Manual P010087-01A Rev. A
4. Troubleshooting
Troubleshooting the FC/FCoE Driver
1068
ACTION: Write the default value.
elx_mes0450: lpfc_%attr attribute cannot be set to , allowed range
is [%min, %max]
DESCRIPTION: Sysfs attribute value written exceeds attribute range.
DATA: (1) attribute name, (2) value written, (3) minimum value, (3) maximum value
ACTION: Write a value within the supported range.
elx_mes0451: Failed to enable interrupt
DESCRIPTION:
DATA: None.
ACTION: None required.
elx_mes0453: Adapter failed to init, mbxCmd
READ_CONFIG, mbxStatus
DESCRIPTION: Adapter initialization failed when issuing a READ_CONFIG mailbox
command.
DATA: None
ACTION: This error could indicate a hardware or firmware issue. If the issue persists,
report the error to Emulex technical support.
elx_mes0456: Adapter failed to issue ASYNCEVT_ENABLE mbox status .
DESCRIPTION: The mailbox command to enable an asynchronous event notification
failed.
DATA: None
ACTION: Ensure the adapter firmware is current. Reload the driver.
elx_mes0457: Adapter Hardware Error
DESCRIPTION: The driver received an interrupt indicating a possible hardware issue.
Data: (1) status, (2) status1, (3) status2
ACTION: This error could indicate a hardware or firmware issue. If the issue persists,
report the error to Emulex technical support.
elx_mes0462: Too many cmd / rsp ring entries in SLI2 SLIM Data:
/home/pely/svn_linux_lpfc_upstream/branches/vmware-8.2.1-ucna/kernel
/lpfc/lpfc_sli.c:
DESCRIPTION:
DATA: None
ACTION: None required.